How can machine-made charcoal machine prevent the surface cr

Recently, our company received a number of new customers return visit, there are many customers because just began to use mechanical charcoal equipment and can not produce high quality charcoal. The reasons are summarized as follows: the process parameter error in the process of carbonization and rod making leads to excessive oxidation of charcoal or cracks on the surface of mechanical carbon. For such a problem, our factory reminds the customers of mechanical charcoal machine not to panic. For specific solutions, we can refer to the experience of our technical personnel, or directly consult our charcoal machinery company by telephone for comprehensive production analysis and technical guidance.

Summary of the solution of producing pyrolysis or machine-made carbon by charcoal machine. 1. The density of rod making is not enough. Semi finished firewood has higher density. Of course, the higher the density, the better the carbonized charcoal. 2. The kiln design is unreasonable. The design of kiln body should be reasonable and the volume should be more than 2.7 × 1.4 × 1.6m. If it is too small, if you can't avoid burning, you will lose your competitive advantage; 3. The sealing performance of the kiln body must be guaranteed. Air leakage will cause charcoal burning and kiln flameout, that is, the welding seam around the furnace should be sealed by carbonization furnace (only mud is needed); 4. Heating speed. The carbonization process should not be too fast, so it is necessary to ensure the carbonization curve and discharge water to a greater extent; 5. Be able to produce qualified high, medium and low temperature carbon according to the requirements of customers and their own carbonization principles. And we can make a clear judgment on the carbonization curve, the color and taste of the flue gas, because the carbonization result is the guarantee of profit. 6. At present, the main carbon chemical industry includes brick kiln and carbonization furnace.

Using charcoal machinery and equipment to produce qualified machine-made charcoal is an ideal production mode for each customer, which can solve a lot of waste of raw materials and manpower loss for enterprises, and reduce the development cost of enterprises. To sum up, the causes of cracks or fracture of mechanical equipment in the production of machine-made charcoal are caused by low rod making density, too fast carbonization temperature rise, poor furnace sealing, unreasonable furnace space design and other reasons.

When encountering the above situation, customers can check step by step according to the above reasons, eliminate the fault, and produce high-quality carbon rods. For charcoal machine equipment used in other difficult problems, users can consult our company.